DTC P2176: Throttle Actuator A Control System - Idle Position Not Learned
WARNING: This page is about a different variant/trim than selected.
P2176 - THROTTLE ACTUATOR A CONTROL SYSTEM - IDLE POSITION NOT LEARNED
| Description: This DTC sets when the PCM is unable to learn the calibrated throttle positions. | |||
Possible Causes:
|
|||
| Diagnostic Aids: This DTC may be accompanied by other DTCs. Diagnose other DTCs first. A TAC motor circuit PID reading may indicate a concern, if available. | |||
| Application | Key On Engine Off | Key On Engine Running | Continuous Memory |
| All | GO to PINPOINT TEST DV . | ||