DTC P1900: Output Shaft Speed (OSS) Sensor Circuit Intermittent
WARNING: This page is about a different variant/trim than selected.
P1900 - OUTPUT SHAFT SPEED (OSS) SENSOR CIRCUIT INTERMITTENT
| Description: The OSS sensor signal to the PCM is irregular or interrupted. | |||
Possible Causes
:
|
|||
| Diagnostic Aids:
Verify harness and connector integrity. Verify correct installation of the OSS sensor. |
|||
| Application | Key On Engine Off | Key On Engine Running | Continuous Memory |
| Manual Transmission | GO to PINPOINT TEST DP . | ||
| Automatic Transmission | Refer to the appropriate Automatic Transaxle/Transmission article, Pinpoint Test Output Shaft Speed Sensor to continue diagnosis. | ||