DTC P0704: Clutch Switch Input Circuit
WARNING: This page is about a different variant/trim than selected.
P0704 - CLUTCH SWITCH INPUT CIRCUIT
| Description: When the clutch pedal is applied the voltage goes to low. This DTC sets if the PCM does not see this change from high to low. | |||
Possible Causes:
|
|||
| Diagnostic Aids: When the clutch pedal is applied and then released, the switch voltage should cycle. | |||
| Application | Key On Engine Off | Key On Engine Running | Continuous Memory |
| All | GO to PINPOINT TEST TA . | ||