DTC P0496: Evaporative Emission System High Purge Flow

WARNING: This page is about a different variant/trim than selected.

P0496 - EVAPORATIVE EMISSION SYSTEM HIGH PURGE FLOW

Description: The PCM monitors the complete evaporative emission (EVAP) control system for high purge flow.
Possible Causes: Aftermarket EVAP hardware that does not conform to the required specifications Small holes or cuts in the fuel vapor hoses/tubes Capless fuel tank filler pipe damaged or not sealed correctly Loose fuel vapor hose or tube connections to the EVAP system components EVAP system component seals leaking at or near the EVAP purge valve
Diagnostic Aids: Verify the capless fuel tank filler pipe is sealed correctly.
Application	Key On Engine Off	Key On Engine Running	Continuous Memory
All	GO to PINPOINT TEST HZ .