DTC P0390: Camshaft Position Sensor B Circuit (Bank 2)
WARNING: This page is about a different variant/trim than selected.
P0390 - CAMSHAFT POSITION SENSOR B CIRCUIT (BANK 2)
| Description: This DTC sets when the PCM can no longer detect the signal from the camshaft position (CMP) sensor (bank 2, sensor 2). For additional CMP sensor location information, refer to ENGINE CONTROL COMPONENTS . | |||
| Possible Causes: See the possible causes for DTC P0340 in P0340 - CAMSHAFT POSITION SENSOR A CIRCUIT (BANK 1 OR SINGLE SENSOR) . | |||
| Diagnostic Aids: See the diagnostic aids for DTC P0340 in P0340 - CAMSHAFT POSITION SENSOR A CIRCUIT (BANK 1 OR SINGLE SENSOR) . | |||
| Application | Key On Engine Off | Key On Engine Running | Continuous Memory |
| All | GO to PINPOINT TEST DR . | ||