DTC P0335: Crankshaft Position Sensor A Circuit
WARNING: This page is about a different variant/trim than selected.
P0335 - CRANKSHAFT POSITION SENSOR A CIRCUIT
| Description: This DTC sets when the crankshaft position (CKP) sensor signal is missing for greater than a calibrated number of camshaft revolutions. | |||
Possible Causes:
|
|||
| Diagnostic Aids: An inactive CKP signal causes a no start condition. Monitor the RPM PID while cranking the engine. A value of 0 RPM indicates a CKP concern. | |||
| Application | Key On Engine Off | Key On Engine Running | Continuous Memory |
| All | GO to PINPOINT TEST JD . | ||