DTC P0171: System Too Lean (Bank 1)

WARNING: This page is about a different variant/trim than selected.

P0171 - SYSTEM TOO LEAN (BANK 1)

Description: The adaptive fuel strategy continuously monitors the fuel delivery hardware. This DTC sets when the adaptive fuel tables reach a rich calibrated limit. Refer to POWERTRAIN CONTROL SOFTWARE , Fuel Trim for additional information.
Possible Causes: Fuel System: Ethanol content in the fuel Fuel filter plugged or dirty Damaged or worn fuel pump Leaking fuel pump check valve Leaking or contaminated fuel injectors Low fuel pressure or running out of fuel EVAP purge valve is leaking when the canister is clean Fuel supply line restricted Fuel rail pressure (FRP) sensor bias Exhaust System: Exhaust leaks in the exhaust manifold gasket or mating gaskets before or near the heated oxygen sensor (HO2S) EGR System: Vacuum hose disconnected on exhaust gas recirculation (EGR) system module (ESM) applications EGR valve tube or gasket leak EGR vacuum regulator solenoid leak Intake Air System: Air leaks after the mass airflow (MAF) sensor Vacuum leaks Positive crankcase ventilation (PCV) system is leaking or the valve is stuck open Incorrectly seated engine oil dipstick Intake air turbulence due to incorrect air filter Damaged or contaminated MAF sensor
Diagnostic Aids: View the freeze frame data to determine the operating conditions when the DTC was set. Observe the LONGFT1 and LONGFT2 PIDs. Refer to ADAPTIVE FUEL DIAGNOSTIC TROUBLE CODE (DTC) DIAGNOSTIC TECHNIQUES , for additional information and the appropriate pinpoint test for specific concern identification.
Application	Key On Engine Off	Key On Engine Running	Continuous Memory
All	GO to PINPOINT TEST H .