LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2012 >> MKZ Hybrid >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 24 (Passive Anti-Theft System (Except Hybrid)) >> General Procedures >> MyKey® Programming >> Clear MyKey™

Clear MyKey™

WARNING: This page is about a different variant/trim than selected.
    NOTE: This procedure is used to clear the MyKey® feature on all of the keys that are programmed to the vehicle. All of the keys then operate as normal (admin) keys with no restrictions.
  1. Using an admin key, turn the ignition ON.
  2. Press SETUP until PRESS RESET TO CLEAR MYKEY appears.
  3. Press and release the RESET button until HOLD RESET TO CONFIRM CLEAR is displayed.
  4. Press and hold the RESET button until ALL MYKEYS CLEARED is displayed.
    • A MyKey® can also be cleared during the same key cycle that it was programmed by following Steps 2, 3 and 4 of this procedure.
scientia non olet · About LEMON Manuals