Selector Lever Bezel - Fusion: Removal

All vehicles 

1. Remove the selector lever trim ring.
   Fig 1: Location of Selector Lever Trim Ring

   Courtesy of FORD MOTOR CO.
2. Remove the center console trim panel.
   Fig 2: Location of Center Console Trim Panel

   Courtesy of FORD MOTOR CO.
3. Remove the utility tray from the center console.
   Fig 3: Location of Center Console Utility Tray

   Courtesy of FORD MOTOR CO.
4. Disconnect the electrical connector and remove the utility tray.
   Fig 4: Location of Utility Tray Electrical Connector

   Courtesy of FORD MOTOR CO.

   Vehicles equipped with a 2.5L or 3.0L (4V) engine 

5. Disconnect the Transmission Control Switch (TCS) or SelectShift™ switch electrical connector.
   Fig 5: Location of Select Switch Electrical Connector

   Courtesy of FORD MOTOR CO.

   All vehicles 

NOTE: TCS shown in illustration, SelectShift™ switch similar.
Fig 6: Sliding Selector Lever Knob Bezel Downward
Courtesy of FORD MOTOR CO.
6. Slide the selector lever knob bezel downward to gain access to the 2 selector lever knob screws.
NOTE: It is necessary to route the Transmission Control Switch (TCS) harness or SelectShift™ switch harness out of the selector lever bezel when removing the selector lever knob.
Fig 7: Location of Selector Lever Knob, Screws And Bezel
Courtesy of FORD MOTOR CO.
7. Remove the 2 screws from the selector lever knob. Remove the selector lever knob and selector lever knob bezel.
8. Disconnect the selector lever bezel electrical connector.
   Fig 8: Location of Selector Lever Bezel Electrical Connector

   Courtesy of FORD MOTOR CO.
NOTE: Selector lever removed for clarity.
Fig 9: Location of Selector Lever Bezel Tabs
Courtesy of FORD MOTOR CO.
9. Release the 3 tabs and remove the selector lever knob bezel.