LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2012 >> MKZ Hybrid >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 20 (Automatic Transaxle External Controls (Except Hybrid)) >> Removal And Installation >> Selector Lever - MKZ >> Removal

Selector Lever - MKZ: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Remove the selector lever bezel. For additional information, refer to SELECTOR LEVER BEZEL - MKZ  .
  2. Remove the PRNDL electrical connector from the RH side of the center console.
    Fig 1: Location of Center Console PRNDL Electrical Connector
    G06275683Courtesy of FORD MOTOR CO.
    3. NOTE: LH shown in illustration, RH similar.
    Fig 2: Location of Center Console Trim Covers
    G06275684Courtesy of FORD MOTOR CO.
  3. Remove the LH and RH center console trim covers.
    4. NOTE: LH shown in illustration, RH similar.
    Fig 3: Location of Center Console-To-Selector Lever Screws
    G07786348Courtesy of FORD MOTOR CO.
  4. Remove the LH and RH center console-to-selector lever screws.
  5. Disconnect the selector lever cable end from the selector lever ball stud.
    Fig 4: Location of Selector Lever Cable End
    G07786349Courtesy of FORD MOTOR CO.
  6. Disconnect the selector lever electrical connector.
    Fig 5: Location of Selector Lever Electrical Connector
    G06275687Courtesy of FORD MOTOR CO.
  7. Remove the 4 selector lever nuts.
    Fig 6: Location of Selector Lever Nuts
    G07786351Courtesy of FORD MOTOR CO.
  8. Position the selector lever off of the studs, release the tab on the selector lever cable and remove it from the selector lever.
    Fig 7: Location of Selector Lever Cable Tab
    G06275689Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals