LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2012 >> MKZ Hybrid >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 20 (Automatic Transaxle External Controls (Except Hybrid)) >> Removal And Installation >> Selector Lever - Fusion >> Removal

Selector Lever - Fusion: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Remove the center console. For additional information, refer to INSTRUMENT PANEL AND CONSOLE .
  2. Disconnect the selector lever cable end from the selector lever.
    Fig 1: Location of Selector Lever Cable End
    G06275674Courtesy of FORD MOTOR CO.
  3. Release the tab on the selector lever cable and remove it from the selector lever housing.
    Fig 2: Location of Selector Lever Cable End Tab
    G06275675Courtesy of FORD MOTOR CO.
  4. Disconnect the electrical connector.
    Fig 3: Location of Electrical Connector
    G06275783Courtesy of FORD MOTOR CO.
  5. Remove the 4 nuts and remove the selector lever.
    Fig 4: Location of Selector Lever Nuts
    G06275784Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals