LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2012 >> MKZ Hybrid >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 19 (Engine Controls - Electronic Engine Controls - 3.5L) >> Removal And Installation >> Crankshaft Position (CKP) Sensor >> Removal and Installation

Removal and Installation

WARNING: This page is about a different variant/trim than selected.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Remove the LH catalytic converter. For additional information, refer to EXHAUST SYSTEM .
  3. Remove the bolt, nut and the heat shield.
    • To install, tighten to 10 Nm (89 lb-in).
  4. Remove the rubber grommet cover.
  5. Disconnect the Crankshaft Position (CKP) sensor electrical connector.
  6. Remove the bolt and the CKP sensor.
    • To install, tighten to 10 Nm (89 lb-in).
  7. To install, reverse the removal procedure.
  8. Using the scan tool, perform the Misfire Monitor Neutral Profile Correction procedure following the on-screen instructions.
scientia non olet · About LEMON Manuals