LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2012 >> MKZ Hybrid >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 19 (Engine Controls - Electronic Engine Controls - 3.5L) >> Removal And Installation >> Camshaft Position (CMP) Sensor >> Removal and Installation

Removal and Installation

WARNING: This page is about a different variant/trim than selected.
  1. Remove the Air Cleaner (ACL) outlet pipe. For additional information, refer to INTAKE AIR DISTRIBUTION AND FILTERING - 3.5L .
  2. Disconnect the Camshaft Position (CMP) sensor electrical connector.
  3. Remove the bolt and the CMP sensor.
    • To install, tighten to 10 Nm (89 lb-in).
    4. NOTE: Lubricate the CMP sensor O-ring seal with clean engine oil.
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals