LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2012 >> MKZ Hybrid >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 18 (Engine Cooling System - (Except Hybrid)) >> Removal And Installation >> Coolant Pump - 3.0L (4V) >> Removal and Installation

Removal and Installation

WARNING: This page is about a different variant/trim than selected.
  1. Drain the cooling system. For additional information, refer to COOLING SYSTEM DRAINING, FILLING AND BLEEDING  .
  2. Remove the Air Cleaner (ACL) outlet pipe. For additional information, refer to INTAKE AIR DISTRIBUTION AND FILTERING - 3.0L (4V) .
  3. Disconnect the lower radiator hose from the thermostat housing.
  4. Remove the coolant pump belt. For additional information, refer to ACCESSORY DRIVE - 3.0L (4V) .
  5. Remove the 3 bolts and the coolant pump.
    • Remove and discard the gasket.
    • To install, tighten to 10 Nm (89 lb-in).
  6. To install, reverse the removal procedure.
    • Install a new gasket.
  7. Fill and bleed the cooling system. For additional information, refer to COOLING SYSTEM DRAINING, FILLING AND BLEEDING  .
scientia non olet · About LEMON Manuals