Drive Pinion Seal: Removal

WARNING: This page is about a different variant/trim than selected.

With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
Remove the driveshaft. For additional information, refer to DRIVESHAFT .
Using the Drive Pinion Flange Holding Fixture, hold the pinion flange and remove the pinion flange nut.
- Discard the nut.
  
  Fig 1: Holding Pinion Flange Using Drive Pinion Flange Holding Fixture
  Courtesy of FORD MOTOR CO.
Index-mark the location of the pinion flange to the yoke.

Fig 2: Identifying Index-Mark On Pinion Flange
Courtesy of FORD MOTOR CO.
Using the 2 Jaw Puller, remove the pinion flange.

Fig 3: Removing Pinion Flange Using Jaw Puller
Courtesy of FORD MOTOR CO.
Using the Converter Seal Remover and Slide Hammer, remove and discard the drive pinion seal.

Fig 4: Removing Drive Pinion Seal Using Torque Converter Fluid Seal Remover And Slide Hammer
Courtesy of FORD MOTOR CO.