LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2012 >> MKZ Hybrid >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (Accessory Drive System - 3.5L) >> Removal And Installation >> Power Steering Pump Belt >> Installation

Power Steering Pump Belt: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Install the power steering belt on the crankshaft pulley.
    2. NOTE: After installation, make sure the belt is correctly seated on the crankshaft and power steering pulleys.
    Fig 1: Positioning Power Steering Belt Around Stretchy Belt Installer Tool And Power Steering Pulley
    G06272442Courtesy of FORD MOTOR CO.
  2. Position the power steering belt around the Stretchy Belt Installer Tool and the power steering pulley. Make sure the belt is engaged with the power steering pulley and rotate the crankshaft clockwise to install the power steering belt.
  3. Position the accessory drive belt on the crankshaft pulley.
    4. NOTE: After installation, make sure the accessory drive belt is correctly seated on all pulleys.
  4. Working from the top of the vehicle, rotate the accessory drive belt tensioner clockwise and install the accessory drive belt on the generator pulley.
  5. Install the RH splash shield and the 6 pin-type retainers.
  6. Position the RH fender splash shield and install the 4 screws.
    Fig 2: View Of RH Fender Splash Shield Mounting Screws
    G06257214Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals