LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2012 >> MKZ Hybrid >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (Accessory Drive System - 3.5L) >> Removal And Installation >> Accessory Drive Belt Tensioner >> Removal

Accessory Drive Belt Tensioner: Removal

WARNING: This page is about a different variant/trim than selected.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Working from the top of the vehicle, rotate the accessory drive belt tensioner clockwise and remove the accessory drive belt from the generator pulley.
  3. Remove the 4 screws and position the RH fender splash shield aside.
    Fig 1: View Of RH Fender Splash Shield Mounting Screws
    G06257214Courtesy of FORD MOTOR CO.
  4. Remove the 6 pin-type retainers and the RH splash shield.
  5. Remove the 3 bolts and the accessory drive belt tensioner.
scientia non olet · About LEMON Manuals