LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2012 >> MKZ Hybrid >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (Accessory Drive System - 3.5L) >> Removal And Installation >> Accessory Drive Belt Tensioner >> Installation

Accessory Drive Belt Tensioner: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Install the accessory drive belt tensioner and the 3 bolts.
    • Tighten to 11 Nm (97 lb-in).
    2. NOTE: After installation, make sure the accessory drive belt is correctly seated on all pulleys.
  2. Working from the top of the vehicle, rotate the accessory drive belt tensioner clockwise and install the accessory drive belt on the generator pulley.
  3. Install the RH splash shield and the 6 pin-type retainers.
  4. Position the RH fender splash shield and install the 4 screws.
    Fig 1: View Of RH Fender Splash Shield Mounting Screws
    G06257214Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals