LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2012 >> MKZ Hybrid >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (HVAC - Climate Control System - General Information And Diagnostics (Except Hybrid)) >> General Procedures >> Fluorescent Dye Leak Detection >> Fluorescent Dye Detection

Fluorescent Dye Detection

WARNING: This page is about a different variant/trim than selected.
NOTE: Ford Motor Company vehicles are produced with R-134a fluorescent dye installed in the refrigerant system from the factory. The location of leaks can be pinpointed by the bright yellow-green glow of the fluorescent dye under a UV lamp. Since more than one leak can exist, make sure to inspect each component, line and fitting in the refrigerant system for a leak.
  1. Check for leaks using a Rotunda-approved UV lamp.
    • Inspect all components, lines and fittings of the refrigerant system.
  2. If a leak is found, recover the refrigerant. For additional information, refer to AIR CONDITIONING (A/C) SYSTEM RECOVERY, EVACUATION AND CHARGING .
  3. Repair the refrigerant system leak(s).
  4. Evacuate and charge the refrigerant system. For additional information, refer to AIR CONDITIONING (A/C) SYSTEM RECOVERY, EVACUATION AND CHARGING .
  5. After the leak(s) is repaired, remove any traces of fluorescent dye with a general purpose oil solvent.
  6. Verify the repair by running the vehicle for a short period of time and rechecking the area of the leak with a Rotunda-approved UV lamp.
scientia non olet · About LEMON Manuals