Valve Tappets
WARNING: This page is about a different variant/trim than selected.
NOTE:
During engine repair procedures, cleanliness is extremely important. Any foreign material, including any material created while cleaning gasket surfaces that enters the oil passages, coolant passages or the oil pan, may cause engine failure.
- Depending on the valve tappets being serviced, remove the LH and/or the RH camshafts. For additional information, refer to CAMSHAFT .
- Remove the valve tappets from the cylinder head.
NOTE:
If the components are to be reinstalled, they must be installed in the same positions. Mark the components for installation into their original locations.