LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2012 >> MKZ Hybrid >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 10 (Engine Mechanical - 3.5L) >> In-Vehicle Repair >> Upper Intake Manifold >> Upper Intake Manifold (View 2 of 2) >> Removal

Upper Intake Manifold (View 2 of 2): Removal

WARNING: This page is about a different variant/trim than selected.
  1. Remove the Air Cleaner (ACL) outlet pipe. For additional information, refer to INTAKE AIR DISTRIBUTION AND FILTERING - 3.5L .
  2. Disconnect the Throttle Body (TB) electrical connector.
  3. Disconnect the Evaporative Emission (EVAP) tube from the intake manifold. For additional information, refer to FUEL SYSTEM - GENERAL INFORMATION .
  4. Disconnect the brake booster vacuum hose from the intake manifold.
  5. Disconnect the PCV tube from the PCV valve.
  6. Detach all the wiring harness retainers from the upper intake manifold.
  7. If equipped, detach the cylinder block heater wiring harness retainer from the upper intake manifold.
  8. Remove the upper intake manifold support bracket bolt.
  9. Remove the 6 bolts and the upper intake manifold.
    • Remove and discard the gaskets.
    • Clean and inspect all of the sealing surfaces of the upper and lower intake manifold.
scientia non olet · About LEMON Manuals