LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2012 >> MKZ Hybrid >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 10 (Engine Mechanical - 3.5L) >> In-Vehicle Repair >> Crankshaft Rear Seal >> Removal

Crankshaft Rear Seal: Removal

WARNING: This page is about a different variant/trim than selected.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Remove the flexplate. For additional information, refer to FLEXPLATE  .
  3. Remove the crankshaft sensor ring.
  4. Using the Crankshaft Rear Oil Seal Remover and Slide Hammer, remove and discard the crankshaft rear seal.
    • Clean all sealing surfaces with metal surface prep.
      Fig 1: Removing Crankshaft Rear Seal Using Crankshaft Rear Oil Seal Remover And Slide Hammer
      G08020673Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals