Transaxle Draining and Filling

WARNING: This page is about a different car, the 2012 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.

MATERIAL SPECIFICATIONS

Item	Specification
SAE 75W-90 API GL-4 Gear Oil XT-4-QGL	WSS-M2C203-A1

Fig 1: Identifying Transaxle Drain Plug And Fill Plug

Courtesy of FORD MOTOR CO.

Item	Part Number	Description
1	-	Transaxle drain plug
2	-	Transaxle fill plug

With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
Remove the drain plug and drain the fluid.
Install a new washer and the drain plug.
- Tighten to 49 Nm (36 lb-ft).

NOTE: Prior to removal, clean the area of the fill plug.

Remove the fill plug.

NOTE: Do not overfill the transaxle. This may result in increased operating temperature or cause transaxle fluid to be forced out of the case.

Fig 2: Identifying Correct Level And Low Level Of Transaxle Fluid

Courtesy of FORD MOTOR CO.

Item	Part Number	Description
1	-	Correct level
2	-	Low level

Fill the transaxle with the recommended fluid.
Install a new washer and fill plug.
- Tighten to 49 Nm (36 lb-ft).