LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2012 >> MKZ Hybrid >> Repair and Diagnosis >> External Pages >> Different car >> Section 1618 (Engine Controls - Electronic Engine Controls - 3.0L (4V)) >> Removal And Installation >> Cylinder Head Temperature (CHT) Sensor

Cylinder Head Temperature (CHT) Sensor

WARNING: This page is about a different car, the 2012 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Cylinder Head Temperature Sensor And Electrical Connector With Torque Specifications
G06096775Courtesy of FORD MOTOR CO.
Item Part Number Description
1 14A464 Cylinder Head Temperature (CHT) sensor electrical connector (part of 12C508)
2 6G004 CHT sensor
NOTE: If the cylinder head is being replaced, the Cylinder Head Temperature (CHT) sensor must be replaced.
  1. Remove the battery tray. For additional information, refer to BATTERY, MOUNTING AND CABLES .
  2. Disconnect the CHT sensor electrical connector.
  3. Remove the CHT sensor.
    • To install, tighten to 11 Nm (97 lb-in).
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals