LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2012 >> MKZ Hybrid >> Repair and Diagnosis >> External Pages >> Different car >> Section 1618 (Engine Controls - Electronic Engine Controls - 3.0L (4V)) >> Removal And Installation >> Crankshaft Position (CKP) Sensor >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2012 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Disconnect the Crankshaft Position (CKP) sensor electrical connector.
  3. Remove the bolt and the CKP.
    • To install, tighten to 10 Nm (89 lb-in).
    • Inspect the O-ring seal and install new as necessary.
    4. NOTE: Lubricate the CKP O-ring seal with clean engine oil.
  4. To install, reverse the removal procedure.
  5. Using the scan tool, perform the Misfire Monitor Neutral Profile Correction procedure following the on-screen instructions.
scientia non olet · About LEMON Manuals