LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2012 >> MKZ Hybrid >> Repair and Diagnosis >> External Pages >> Different car >> Section 1617 (Accessory Drive System - 3.0L (4V)) >> Removal And Installation >> Coolant Pump Belt >> Installation

Coolant Pump Belt: Installation

WARNING: This page is about a different car, the 2012 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the coolant pump belt on the coolant pump pulley and position it on the camshaft pulley.
    Fig 1: Installing Coolant Pump Belt
    G06095898Courtesy of FORD MOTOR CO.
    2. NOTE: Do not use any screwdrivers, pliers or other metal objects that could cause damage to the belt or camshaft pulley while installing the belt.
  2. Rotate the crankshaft clockwise to seat the coolant pump belt on the camshaft pulley.
  3. Install the RH splash shield and the 6 pin-type retainers.
    Fig 2: View Of Pin-Type Retainers And RH Splash Shield
    G06272546Courtesy of FORD MOTOR CO.
  4. Position the RH fender splash shield and install the 4 screws.
    Fig 3: View Of RH Fender Splash Shield Mounting Screws
    G06257214Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals