LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2012 >> MKZ Hybrid >> Repair and Diagnosis >> External Pages >> Different car >> Section 1617 (Accessory Drive System - 3.0L (4V)) >> Removal And Installation >> Accessory Drive Belt >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2012 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Remove the 4 screws and position the RH fender splash shield aside.
    Fig 1: View Of RH Fender Splash Shield Mounting Screws
    G06257214Courtesy of FORD MOTOR CO.
  3. Remove the 6 pin-type retainers and the RH splash shield.
    Fig 2: View Of Pin-Type Retainers And RH Splash Shield
    G06272546Courtesy of FORD MOTOR CO.
  4. Rotate the accessory drive belt tensioner counterclockwise and remove the accessory drive belt.
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals