Removal and Installation

WARNING: This page is about a different car, the 2012 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.

With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
Remove the 4 screws and position the RH fender splash shield aside.

Fig 1: View Of RH Fender Splash Shield Mounting Screws
Courtesy of FORD MOTOR CO.
Remove the 6 pin-type retainers and the RH splash shield.
Using the hex feature, rotate the accessory drive belt tensioner clockwise and remove the accessory drive belt from the coolant pump pulley.
- Remove the accessory drive belt from the engine.
  
  Fig 2: Removing Accessory Drive Belt From Engine
  Courtesy of FORD MOTOR CO.
To install, reverse the removal procedure.