Removal and Installation

WARNING: This page is about a different car, the 2012 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.

With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
Remove the 4 screws and position the RH fender splash shield aside.

Fig 1: View Of RH Fender Splash Shield Mounting Screws
Courtesy of FORD MOTOR CO.
Remove the 6 pin-type retainers and the RH splash shield.
Using the hex feature, rotate the accessory drive belt tensioner clockwise and remove the accessory drive belt from the coolant pump pulley.

Fig 2: Removing Accessory Drive Belt From Coolant Pump Pulley
Courtesy of FORD MOTOR CO.

NOTE: The accessory drive belt tensioner must be replaced as a complete unit.

Remove the 2 bolts and the accessory drive belt tensioner.
- To install, tighten to 25 Nm (18 lb-ft).
To install, reverse the removal procedure.