LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2012 >> MKZ Hybrid >> Repair and Diagnosis >> External Pages >> Different car >> Section 1614 (Automatic Transaxle (6F35)) >> In-Vehicle Repair >> Turbine Shaft Speed (TSS) Sensor >> Removal

Turbine Shaft Speed (TSS) Sensor: Removal

WARNING: This page is about a different car, the 2012 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Remove the 6 pin-type retainers and the LH front structure-to-subframe splash shield.
    Fig 1: Locating LH Front Structure-To-Subframe Splash Shield
    G06264039Courtesy of FORD MOTOR CO.
  3. Disconnect the Turbine Shaft Speed (TSS) sensor electrical connector.
    Fig 2: Locating Turbine Shaft Speed (TSS) Sensor Electrical Connector
    G06097285Courtesy of FORD MOTOR CO.
  4. Remove the bolt and the TSS sensor.
    Fig 3: Locating Bolt And TSS Sensor
    G06097208Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals