Removal and Installation

WARNING: This page is about a different car, the 2012 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.

Remove the engine coolant degas bottle. For additional information, refer to ENGINE COOLING .
Remove the bolt and position aside the ground wire.
- To install, tighten to 10 Nm (89 lb-in).
Remove the bolt and damper.
- To install, tighten to 23 Nm (17 lb-ft).
Remove the engine support insulator bracket bolt.
- To install, tighten to 115 Nm (85 lb-ft).

NOTE: Failure to position the wood block and floor jack as illustrated can result in damage to the oil pan.

Position a floor jack with a block of wood under the front of the oil pan.
- Using the floor jack, lift the engine 12 mm (0.47 in).
  
  Fig 1: Positioning Floor Jack With Block Of Wood Under Front Of Oil Pan
  Courtesy of FORD MOTOR CO.
Remove the 3 nuts and the engine support insulator bracket.
- To install, tighten to 63 Nm (46 lb-ft).
Remove the nut, 2 bolts and the engine mount.
- To install, tighten to 55 Nm (41 lb-ft).

NOTE: If the engine mount bracket is to be removed, the engine must be lowered to avoid contact between the A/C tubes and the engine mount bracket.

Use the floor jack to lower the engine 25 mm (0.98 in).
- Remove the engine mount bracket.
To install, reverse the removal procedure.