LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2012 >> MKZ Hybrid >> Repair and Diagnosis >> External Pages >> Different car >> Section 1612 (Engine Mechanical - 2.5L (Except Hybrid)) >> In-Vehicle Repair >> Exhaust Manifold >> Removal

Exhaust Manifold: Removal

WARNING: This page is about a different car, the 2012 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Remove the exhaust flexible pipe. For additional information, refer to EXHAUST SYSTEM .
  3. Disconnect the Heated Oxygen Sensor (HO2S) electrical connector.
  4. Remove the 4 exhaust manifold heat shield bolts and the heat shield.
  5. If equipped, detach the block heater wire harness retainer from the exhaust manifold stud.
  6. Remove and discard the 7 exhaust manifold nuts.
  7. Remove the exhaust manifold and discard the exhaust manifold gasket.
  8. Remove and discard the 7 cylinder head studs.
  9. Clean and inspect the exhaust manifold. For additional information, refer to ENGINE SYSTEM - GENERAL INFORMATION .
scientia non olet · About LEMON Manuals