Removal and Installation
NOTE:
When prying on a component, a non-marring tool must be used or damage to the component may occur.
- Position the front seats forward and remove the 2 floor console rear screws.
- Position the front seats rearward.
- Pull the parking brake handle upward.
- If equipped with an automatic transmission, remove the selector lever trim ring.
- Using a non-marring tool, pry upward to release the retaining clips.
- If equipped with a manual transmission, remove the gearshift knob by turning in a counterclockwise direction.
- Open the storage compartment door and remove the floor console finish panel.
- Using a non-marring tool, pry upward to release the retaining clips.
- Disconnect the electrical connectors, if equipped.
- Remove the utility tray.
- Using a non-marring tool, pry upward to release the retaining clips.
- Disconnect the electrical connector.
- Disconnect the audio jack connector, if equipped.
- Remove the 2 floor console screw covers.
- Remove the 2 floor console front screws.
- Disconnect the power point and bulkhead electrical connectors. Detach the electrical connector pin-type retainer.
- Remove the 4 floor console screws, place the selector lever in NEUTRAL, pull the console towards the rear of the vehicle and remove the floor console.
- To install, reverse the removal procedure.
NOTE:
To prevent damage to the instrument panel, place the selector lever in NEUTRAL and pull the console towards the rear of the vehicle when removing the console.