DTC Charts
NOTE:
This module utilizes a 5-character DTC followed by a 2-character failure-type code. The failure-type code provides information about specific fault conditions such as opens, or shorts to ground. Continuous memory DTCs have an additional 2-character DTC status code suffix to assist in determining DTC history.
SIDE OBSTACLE DETECTION CONTROL MODULE - LEFT (SOD-L) AND SIDE OBSTACLE DETECTION CONTROL MODULE - RIGHT (SOD-R) DTC CHART
| DTC | Description | Action |
|---|---|---|
| B11D6:11 | Driver Display Alert LED: Circuit Short To Ground | GO to Pinpoint Test D . |
| B11D6:15 | Driver Display Alert LED: Circuit Short To Battery Or Open | GO to Pinpoint Test D . |
| U2100:00 | Initial Configuration Not Complete: No Sub Type Information | The Side Obstacle Detection Control Module - Left (SOD-L) or Side Obstacle Detection Control Module - Right (SOD-R) is not configured. REFER to MODULE CONFIGURATION for Programmable Module Installation (PMI) to configure the SOD-L or SOD-R. CLEAR all DTCs. TEST the system for normal operation. |
| U0155:00 | Lost Comunitcation With Instrument Panel Cluster (IPC) Control Module: No Sub Type Information | GO to Pinpoint Test J . |
| U0423:00 | Invalid Data Received From Instrument Panel Cluster Control Module: No Sub Type Information | DTC U0423:00 is set when the SOD-L or SOD-R receives invalid network data from the IPC. RETRIEVE and REPAIR all non-network DTCs in the IPC. REFER to INSTRUMENTATION, MESSAGE CENTER, AND WARNING CHIMES . |
| U3000:44 | Control Module: Data Failure | GO to Pinpoint Test H . |
| U3000:45 | Control Module: Program Memory Failure | GO to Pinpoint Test H . |
| U3000:46 | Control Module: Calibration/Parameter Memory Failure | GO to Pinpoint Test H . |
| U3000:48 | Control Module: Supervision Software Failure | GO to Pinpoint Test H . |
| U3000:49 | Control Module: Internal Electronic Failure | GO to Pinpoint Test H . |
| U3000:4A | Control Module: Incorrect Component Installed | GO to Pinpoint Test H . |
NOTE:
This module utilizes a 5-character DTC followed by a 2-character failure-type code. The failure-type code provides information about specific fault conditions such as opens, or shorts to ground. Continuous memory DTCs have an additional 2-character DTC status code suffix to assist in determining DTC history.
INSTRUMENT PANEL CLUSTER (IPC) DTC CHART
| DTC | Description | Action |
|---|---|---|
| U0232:00 | Lost Communication With Side Obstacle Detection Control Module Left: No Sub-Type Information | REFER to INSTRUMENTATION, MESSAGE CENTER, AND WARNING CHIMES . |
| U0233:00 | Lost Communication With Side Obstacle Detection Control Module Right: No Sub-Type Information | REFER to INSTRUMENTATION, MESSAGE CENTER, AND WARNING CHIMES . |