LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2012 >> MKZ Hybrid >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Mechanical >> Engine Mechanical - 2.5L (Hybrid) >> In-Vehicle Repair >> Oil Pump >> Removal

Oil Pump: Removal

  1. With the engine in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Remove the engine front cover. For additional information, refer to ENGINE FRONT COVER  .
  3. Drain the engine oil, then install the drain plug.
    • To install, tighten to 28 Nm (21 lb-ft).
  4. Remove the 4 oil pan-to-bellhousing bolts.
  5. Remove the 13 bolts and the oil pan.
    6. NOTE: Discard the gasket and clean and inspect the gasket mating surfaces.
  6. Remove the 2 bolts and the oil pump screen and pickup tube.
  7. Remove the oil pump drive chain tensioner.
    1. Release the tension on the tensioner spring.
    2. Remove the 2 shoulder bolts and the tensioner.
      Fig 1: Identifying Oil Pump Chain Drive Tensioner And Shoulder Bolts
      G06095011Courtesy of FORD MOTOR CO.
  8. Remove the chain from the oil pump sprocket.
  9. Remove the bolt and oil pump sprocket.
  10. Remove the 4 bolts and the oil pump.
scientia non olet · About LEMON Manuals