LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2012 >> MKZ Hybrid >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Mechanical >> Engine Mechanical - 2.5L (Hybrid) >> In-Vehicle Repair >> Engine Oil Pressure (EOP) Switch >> Removal and Installation

Removal and Installation

  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Disconnect the Engine Oil Pressure (EOP) switch electrical connector.
  3. Remove the EOP switch.
    • To install, tighten to 15 Nm (133 lb-in).
  4. To install, reverse the removal procedure.
    • Apply thread sealant with PTFE to the EOP switch threads.
scientia non olet · About LEMON Manuals