LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2012 >> MKZ Hybrid >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Mechanical >> Engine Mechanical - 2.5L (Hybrid) >> In-Vehicle Repair >> Crankshaft Rear Seal >> Removal

Crankshaft Rear Seal: Removal

  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Remove the flywheel. For additional information, refer to FLYWHEEL  .
  3. Drain the engine oil.
    • Install the drain plug.
    • Tighten to 28 Nm (21 lb-ft).
    4. NOTE: If the oil pan is not removed, damage to the rear oil seal retainer joint can occur.
  4. Remove the 17 bolts and the oil pan.
  5. Remove the 6 bolts and the crankshaft rear oil seal with retainer plate.
scientia non olet · About LEMON Manuals