LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2012 >> MKZ Hybrid >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Cooling System (Mechanical) >> Engine Cooling System (Hybrid) >> Removal And Installation >> Cooling Fan Motor and Shroud >> Cooling Fan and Shroud (View 2 of 2) >> Removal and Installation

Removal and Installation

  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. If equipped, detach the 2 block heater wiring retainers from the cooling fan motor and shroud.
  3. Remove the splash shield.
    Fig 1: Locating Splash Shield
    G06272329Courtesy of FORD MOTOR CO.
  4. Detach the lower radiator hose pin-type retainer from the cooling fan motor and shroud.
  5. Remove the battery tray. For additional information, refer to BATTERY, MOUNTING AND CABLES .
  6. Remove the 2 bolts and position the auxiliary relay box aside.
    • To install, tighten to 8 Nm (71 lb-in).
  7. Detach all the wiring harness retainers from the cooling fan and shroud.
  8. Disconnect the Evaporative Emission (EVAP) canister purge valve electrical connector.
  9. Disconnect the cooling fan electrical connector.
    10. NOTE: LH shown in illustration, RH similar.
    Fig 2: Locating Cooling Fan Shroud Tabs
    G06272330Courtesy of FORD MOTOR CO.
  10. Release the 2 tabs and remove the cooling fan motor and shroud.
  11. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals