Removal and Installation

With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
Remove the 4 screws and position the RH fender splash shield aside.

Fig 1: View Of RH Fender Splash Shield Mounting Screws
Courtesy of FORD MOTOR CO.
Remove the 6 pin-type retainers and the RH splash shield.

Fig 2: View Of Pin-Type Retainers And RH Splash Shield
Courtesy of FORD MOTOR CO.
Remove the A/C hose retainer bracket bolt.
- To install, tighten to 6 Nm (53 lb-in).
  
  Fig 3: View Of A/C Hose Retainer Bracket Bolt
  Courtesy of FORD MOTOR CO.
Rotate the accessory drive belt tensioner counterclockwise and remove the accessory drive belt.
To install, reverse the removal procedure.