Service Roll Stability Control (RSC®) Warning Chime

The service RSC® warning chime warns that the ABS module has detected a fault condition in the RSC® system. The SERVICE ADVANCETRAC message is also displayed along with the chime.

The service RSC® chime sounds for approximately 3 seconds following an initial delay of 8 seconds following key ON. The RSC® chime stops sounding when the ignition switch is turned from the RUN/START position to the OFF/LOCK or ACC position or when fault condition is repaired.

The service RSC® warning chime inputs are:

• Ignition state.
• Service RSC® chime request communicated by the ABS module to the IPC through the HS-CAN.