LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2012 >> MKZ Hybrid >> Repair and Diagnosis (Single Page) >> Brakes >> Anti-Lock Brakes >> Anti-Lock Brake System And Stability Control >> Diagnosis And Testing >> Anti-Lock Control - Non-Hybrid >> Pinpoint Tests >> Pinpoint Test H: DTCs B2900 and C1805 >> PINPOINT TEST H: DTCs B2900 AND C1805

PINPOINT TEST H: DTCs B2900 AND C1805

  1. H1 VERIFY PCM VIN 
    • Connect the scan tool.
    • Ignition ON.
    • Using the scan tool, carry out the Network Test.
    • Enter the following diagnostic mode on the scan tool: Log Viewer.
    • Compare the VIN in Log Viewer to the vehicle VIN plate.
    • Does VIN in Log Viewer match the vehicle VIN plate? 
      • Yes:  GO to H2.
      • No:  RECONFIGURE the PCM. FOLLOW the instructions on the scan tool. CLEAR the DTCs. CYCLE the ignition key. REPEAT the self-test.
  2. H2 VERIFY ABS MODULE PART NUMBER 
    • Retrieve and record the ABS module part number from Log Viewer and verify that the vehicle has the correct ABS module installed.
    • Is the correct ABS module installed in the vehicle? 
      • Yes:  CONFIGURE the ABS module. REFER to Programmable Module Installation (PMI) Using the Integrated Diagnostic System (IDS) When the Original Module is NOT Available in MODULE CONFIGURATION . CLEAR the DTC. CYCLE the ignition key. REPEAT the self-test.
      • No:  INSTALL a new ABS module. REFER to ANTI-LOCK BRAKE SYSTEM (ABS) MODULE  . CLEAR the DTC. CYCLE the ignition key. REPEAT the self-test.
scientia non olet · About LEMON Manuals