Removal and Installation

Remove the rear seat cushion. For additional information, refer to Seat Cushion - Rear .
If equipped, remove 5 screws and the grille.
If equipped, remove the hog rings retaining the cushion cover wire to the cushion foam pad wire and the draw strings to the cover wires.

Fig 1: Location of Screws And Grille
Courtesy of FORD MOTOR CO.
If equipped, separate the cushion cover retainers attached to the hard foam.

Fig 2: Location of Cushion Cover Retainers
Courtesy of FORD MOTOR CO.
Invert the cushion cover.

NOTE: Use care when separating the cushion cover from the hook-and-loop strip, or the hook-and-loop strip can be torn from the cushion foam pad.

Remove the hog rings (if equipped), separate the hook-and-loop strips and remove the cushion cover.
To install, reverse the removal procedure.