LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2012 >> MKZ Hybrid >> Repair and Diagnosis (Single Page) >> Body & Frame >> Seat System - Seats >> Diagnosis And Testing >> Seats >> Pinpoint Tests >> Pinpoint Test D: The Power Seat is Inoperative - Fusion, Passenger >> Pinpoint Test D: The Power Seat Is Inoperative - Fusion, Passenger

Pinpoint Test D: The Power Seat Is Inoperative - Fusion, Passenger

NOTE: If a seat equipped with a seat mounted side air bag is being serviced, the Supplemental Restraint System (SRS) must be depowered. Refer to SUPPLEMENTAL RESTRAINT SYSTEM .
NOTE: The air bag warning lamp illuminates when the Restraints Control Module (RCM) fuse is removed and the ignition switch is ON. This is normal operation and does not indicate an SRS fault.
NOTE: The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
  1. D1 CHECK FOR VOLTAGE AT THE SEAT CONTROL SWITCH 
    • Ignition OFF.
    • Depower the SRS. Refer to Supplemental Restraint System (SRS) Depowering and Repowering in the General Procedures portion of SUPPLEMENTAL RESTRAINT SYSTEM .
    • Disconnect: Passenger Seat Side Air Bag C313.
    • Disconnect: Passenger Seat Control Switch C330.
      • WARNING: Make sure no one is in the vehicle and there is nothing blocking or placed in front of any air bag module when the battery is connected. Failure to follow these instructions may result in serious personal injury in the event of an accidental deployment.
    • Connect the battery ground cable. Refer to BATTERY, MOUNTING AND CABLES .
    • Measure the voltage between passenger seat control switch C330-5, circuit SBB31 (WH/RD), harness side and ground.
      Fig 1: Measuring Voltage Between Passenger Seat Control Switch C330-5, Circuit SBB31 (WH/RD), Harness Side And Ground
      G06134176Courtesy of FORD MOTOR CO.
    • Is the voltage greater than 10 volts? 
      • Yes:  GO to D2.
      • No:  VERIFY Battery Junction Box (BJB) fuse 31 (30A) is OK. If OK, REPAIR the circuit. If not OK, REFER to the Wiring Diagrams informationi to identify the possible causes of the circuit short. TEST the system for normal operation.

        DISCONNECT the battery ground cable. CONNECT passenger seat side air bag module C313. REPOWER the SRS. REFER to SUPPLEMENTAL RESTRAINT SYSTEM .

  2. D2 CHECK FOR GROUND TO THE SEAT CONTROL SWITCH 
    • Measure the resistance between passenger seat control switch C330-3, circuit GD139 (BK/YE), harness side and ground.
      Fig 2: Measuring Resistance Between Passenger Seat Control Switch C330-3, Harness Side And Ground
      G06134177Courtesy of FORD MOTOR CO.
    • Is the resistance less than 5 ohms? 
      • Yes:  INSTALL a new passenger seat control switch. REFER to Seat Control Switch  . TEST the system for normal operation.

        DISCONNECT the battery ground cable. CONNECT passenger seat side air bag module C313. REPOWER the SRS. REFER to SUPPLEMENTAL RESTRAINT SYSTEM .

      • No:  REPAIR the circuit. TEST the system for normal operation.

        DISCONNECT the battery ground cable. CONNECT passenger seat side air bag module C313. REPOWER the SRS. REFER to SUPPLEMENTAL RESTRAINT SYSTEM .

scientia non olet · About LEMON Manuals