LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2012 >> MKZ Hybrid >> Repair and Diagnosis (Single Page) >> Body & Frame >> Seat System - Seats >> Diagnosis And Testing >> Seats >> Pinpoint Tests >> Pinpoint Test B: DTCs B106E and B106F >> PINPOINT TEST B: DTCs B106E, B106F

PINPOINT TEST B: DTCs B106E, B106F

NOTE: If DTC B106F is present, the fault condition must be corrected prior to installing a new DSM. Failure to correct the fault condition first may cause damage to the new DSM, resulting in a repeat repair.
  1. B1 REVIEW THE DTCs 
    • Review the DTCs from the DSM self-test.
    • Are DTCs B106F and B1342 present? 
      • Yes:  CORRECT the cause of any other DTCs present. When the other DTCs are corrected, INSTALL a new DSM. REFER to Driver Seat Module (DSM)  . TEST the system for normal operation.
      • No:  GO to B2.
  2. B2 REPAIR OTHER DTCs 
    • Repair the cause of any DTCs present, other than DTC B106E. Refer to DTC Charts  .
    • Clear the DTCs.
    • Carry out the DSM self-test.
    • Is DTC B106E still present? 
      • Yes:  The fault causing the output state to be disabled is still present. REPAIR the cause of the concern. CLEAR the DTCs. REPEAT the self-test.
      • No:  The system is operating correctly at this time. The concern was caused by a fault in one of the output circuits.
scientia non olet · About LEMON Manuals