LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2012 >> MKZ Hybrid >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Wiper/Washer Systems >> Wiper System & Washer System >> Removal And Installation >> Wiper Mounting Arm and Pivot Shaft >> Removal and Installation

Removal and Installation

  1. Remove the upper cowl panel grille. For additional information, refer to FRONT END BODY PANELS .
  2. Disconnect the windshield wiper motor electrical connector.
  3. Remove the 2 windshield wiper mounting arm and pivot shaft assembly bolts and the windshield wiper mounting arm and pivot shaft assembly.
    • To install, tighten to 5 Nm (44 lb-in).
    Fig 1: Location of Windshield Wiper Mounting Arm And Pivot Shaft Assembly Bolts
    G06271587Courtesy of FORD MOTOR CO.
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals