Removal and Installation
NOTE:
This procedure applies to the stand-alone satellite radio antenna, the combination AM/FM/satellite radio antenna, and the combination satellite radio/Global Positioning System (GPS) antenna.
- Remove the LH and RH assist handles. For additional information, refer to Headliner in INTERIOR TRIM AND ORNAMENTATION .
- Remove the LH and RH C-pillar trim panels. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION .
- Carefully lower the rear of the headliner to gain access to the satellite radio antenna.
- Loosen the satellite radio antenna cable bolt and disconnect the cable from the antenna.
- To install, tighten to 8 Nm (71 lb-in).
- Remove the antenna.
- Remove the antenna mast, if equipped.
- Press the 2 tabs and remove the satellite radio antenna.
- To install, reverse the removal procedure.