Pinpoint Test H: DTC U3000:44, 45, 46, 48, 49 Or 4A
- H1 CHECK THE SOD-R and SOD-L FOR DTCs
- Ignition ON.
- Enter the following diagnostic mode on the scan tool: SOD-R and SOD-L Module Self-Test.
- Clear the DTCs.
- Ignition OFF.
- Wait 5 seconds
- Ignition ON.
- Repeat the SOD-R and SOD-L module self-test.
- Are any U3000 DTCs present?
- Yes:
INSTALL a new SOD-R or SOD-L. REFER to Side Obstacle Detection (SOD) Module
. TEST the system for normal operation.
- No:
The system is operating correctly at this time. The concern may have been caused by an intermittent problem.