LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2012 >> MKX AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 783 (Transfer Case - Four Wheel Drive (4WD) Systems -- F250-F550 Super Duty) >> Removal And Installation >> 4X4 Control Module >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Prior to removal of the 4X4 control module, it is necessary to upload module configuration information to a diagnostic tool. This information needs to be downloaded into the new module once installed. For additional information, refer to MODULE CONFIGURATION article.
  1. Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES article.
  2. Open and lower the glove box compartment.
  3. Disconnect the connectors from the 4X4 control module.
    4. Fig 1: Disconnecting Connectors From 4WD Module
    GF0007477Courtesy of FORD MOTOR CO.
  4. Remove 2 nuts and the 4X4 control module.
    5. Fig 2: Locating 4WD Control Module Nuts
    GF0007478Courtesy of FORD MOTOR CO.
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals