Pinpoint Test H: The Tachometer Is Inoperative
- H1 RETRIEVE THE RECORDED DTCs FROM THE PCM KOEO SELF-TEST
- Check for recorded PCM DTCs from the Key ON Engine OFF (KOEO) self-test.
- Are any DTCs recorded?
- Yes : DIAGNOSE all PCM DTCs first. REFER to the INTRODUCTION - GASOLINE MODELS .
- No : GO to H2.
- H2 CARRY OUT THE TACHOMETER ACTIVE COMMAND USING THE SCAN TOOL
- Ignition ON.
- Enter the following diagnostic mode on the scan tool: IPC DataLogger.
- Select the IPC tachometer (TACH_IND) active command. Command the tachometer in 10% increments while monitoring the tachometer.
- Does the tachometer increase approximately 700 RPM with each 10% increment?
- Yes : GO to H3.
- No : INSTALL a new IPC. REFER to INSTRUMENT PANEL CLUSTER (IPC) . TEST the system for normal operation.
- H3 RETRIEVE THE RECORDED DTCs FROM THE IPC SELF-TEST
- Check for recorded DTCs from the IPC self-test.
- Are any DTCs recorded?
- Yes
: For DTC U0100:00, GO to PINPOINT TEST AO .
For DTC U0401:68, RETRIEVE and REPAIR all non-network DTCs in the PCM and other modules on the network. REFER to MULTIFUNCTION ELECTRONIC MODULES for a list of all DTCs.
For all other DTCs, REFER to DTC CHARTS .
- No : INSTALL a new PCM. REFER to ELECTRONIC ENGINE CONTROLS . TEST the system for normal operation.