Pinpoint Test Ar: DTC U0121:00
- AR1 VERIFY THE CUSTOMER CONCERN
- Ignition ON.
- Verify that there is an observable symptom present.
- Is an observable symptom present?
- Yes : GO to AR2.
- No : The system is operating normally at this time. The DTC may have been set due to high network traffic or an intermittent fault condition.
- AR2 CHECK THE COMMUNICATION NETWORK
- Ignition ON.
- Enter the following diagnostic mode on the scan tool: Network Test.
- Carry out the network test.
- Does the ABS module pass the network test?
- Yes : GO to AR3.
- No : REFER to MODULE COMMUNICATIONS NETWORK .
- AR3 RETRIEVE THE RECORDED DTCs FROM THE IPC SELF-TEST
- Check for recorded DTCs from the IPC self-test.
- Is DTC U3003:16 or DTC U3003:17 recorded?
- Yes : GO to PINPOINT TEST BF (U3003:16) or GO to PINPOINT TEST BG (U3003:17).
- No : GO to AR4.
- AR4 RECHECK THE IPC DTCs NOTE: If new modules were installed prior to the DTC being set, the module configuration may be incorrectly set during the Programmable Module Installation (PMI) or the PMI may not have been carried out.
- Clear the DTCs. Repeat the IPC self-test.
- Is DTC U0121:00 still present?
- Yes
: INSTALL a new ABS module. REFER to
VEHICLE DYNAMIC SYSTEMS
. CLEAR the DTCs. REPEAT the IPC self-test.
If DTC U0121:00 is still present, INSTALL a new IPC. REFER to INSTRUMENT PANEL CLUSTER (IPC) . TEST the system for normal operation.
- No : The system is operating correctly at this time. The DTC may have been set due to high network traffic or an intermittent fault condition.